How goes Harmony Hub implementations?

Try removing ipv6 networking.  See myserver startup documentation.  Bottom of doc

Sounds like a network issue

Thanks David. I’ve checked - my router has ipv6 disabled.

CrabbyPatties wrote:

Thanks David. I’ve checked - my router has ipv6 disabled.

Please reread the docs to disable IPV6 on the myServer controller (not just the router)

I've reread the docs and now disabled ipv6 on the pi for ethernet connection (from networking settings on the taskbar). Will let you know if it makes a difference. If it is not required, perhaps it should be off by default?

CrabbyPatties wrote:

I've reread the docs and now disabled ipv6 on the pi for ethernet connection (from networking settings on the taskbar). Will let you know if it makes a difference. If it is not required, perhaps it should be off by default?

yup, it is very likely that ipv6 will be disabled by default in the next Master Image.  Hopefully that helps your situation.

David Li wrote:

CrabbyPatties wrote:

I've reread the docs and now disabled ipv6 on the pi for ethernet connection (from networking settings on the taskbar). Will let you know if it makes a difference. If it is not required, perhaps it should be off by default?

yup, it is very likely that ipv6 will be disabled by default in the next Master Image.  Hopefully that helps your situation.

I'm afraid it hasn't.  Hub has fallen off again.  Not responding to any commands.