Basic functions of SmartRemote not working.

Help in that area would be greatly appreciated!

Once I get the remote working I will need to create macros to get everything on and to the correct inputs.

FYI, since my Harmony Elite hasn’t fully stopped working I haven’t been working on this for awhile.

Time to get her working.

Any help is appreciated!

So you are using the Harmony driver to configure your SmartRemote?  That is where I can help you,   What is on and what signal goes where is all in the Harmony driver.
Chris

No, I purchased the Allonis system because my 2nd Harmony Elite with hub is on its last leg and they don’t make a new one.

Basically, I’m looking to replace my Harmony Elite, remote and hub with the Allonis system.

That is a harder road to take especially if you are already on the Harmony ecosystem.  You can grab a hub (and remote) all day long on eBay for buck and a quarter.   Anyway good luck with your project.  The Allonis software is a little mysterious at times but you can do great custom stuff with it with a little patience.
Chris