myServer 6 supports the Phillips Hue brand of connected lights.
The myServer controller communicates to the Hue Bridge, which then communicates to the individual Hue lights.
Dependent on the bulb, On / Off / Dim and colors are supported.
Installation
- Ensure that myServer is on the same network subnet as the Bridge to ensure it's found.
- Install the Phillips Hue driver from myServer Software Updater.
- Click the Setup button on the Hue Bridge.
- Run the Discover command in the myServer Hue Driver Command Builder.
In a few minutes, your Hue Bridge should be auto discovered. You can then try commands in the Command Builder.
Device type should be "Lighting".